Twin Clutch SST Control Mode Switch Check

WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Check the continuity between the connector terminals of twin clutch SST control mode switch.

Terminal number	Switch position	Continuity
2 - 3	Operate to direction A, then hold.	Yes (2 Ω or less)
2 - 3	Other than above	Not present
1 - 3	Operate to direction B, then hold.	Yes (2 Ω or less)
1 - 3	Other than above	Not present

When other than above, replace the twin clutch SST control mode switch.

Fig 1: Checking Continuity Between Connector Terminals Of Twin Clutch SST Control Mode Switch
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.