<< A >> Pull Ring Removal

WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Pull the pull ring upward as shown in the illustration. (Carry out the following operation with the pull ring pulled upward.)

Fig 1: Pulling Transaxle Control Cable Ring
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Raise the claw using a precision screwdriver.

Fig 2: Removing Claw Using Screwdriver
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Remove the pull ring by turning it clockwise, and pull it out upward.

Fig 3: Removing Pull Ring
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 4: Removing Transaxle Control Cable Ring
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.