>> B << Gasket A/Gasket C/MECHATRONIC Assembly Installation

WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

As shown in the illustration, fix the gasket to the transaxle case by pushing the gasket at the area to which the gasket dowel pin is inserted.

Fig 1: Fixing Gasket To Transaxle Case
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Inserting Dowel Pin
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Install the mechatronic assembly carefully and tighten the mechatronic assembly mounting bolts to the specified torque in the order of number shown in the illustration.
Tightening torque: 5.0 ± 1.0 N.m (44 ± 8 in-lb)
Tighten again the mechatronic assembly mounting bolts to the specified torque in the order of number shown in the illustration.
Tightening torque: 10 ± 1.5 N.m (89 ± 8 in-lb)

Fig 3: Mechatronic Assembly Mounting Bolts Tightening Sequence
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

CAUTION: When installing bolt, use magnetic tools to prevent them from falling out.

5. Tighten the bolts to the specified torque.
Tightening torque: 6.0 ± 1.0 N.m (53 ± 8 in-lb)
6. Install the connector.

Fig 4: Identifying Mechatronic Assembly Bolts
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.