LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2017 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Twin Clutch-SPORTRONIC Shift Transmission (TC-SST) - With Diagnostics - Lancer (6 Of 6)) >> MECHATRONIC Assembly, Manual Control Lever >> Removal And Installation >> Installation Service Points >> >> A << Manual Control Shaft/Bolt/Plug Installation

>> A << Manual Control Shaft/Bolt/Plug Installation

WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When installing bolt, use magnetic tools to prevent them from falling out.
  1. Install the manual control shaft carefully and tighten the bolt to the specified torque.

    Tightening torque: 10 ± 1.5 N.m (89 ± 8 in-lb) 

    Fig 1: Identifying Control Shaft Bolt
    G06471490Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Tighten the plug to the specified torque.

    Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb) 

    Fig 2: Identifying Control Shaft Plug
    G06471489Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals