Freeze Frame Data Check

WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Various data of when the diagnostic trouble code is determined is obtained, and the status of that time is stored. By analyzing each data using the scan tool, troubleshooting can be performed efficiently.

Display items of the freeze frame data are as follows.

FREEZE FRAME DATA REFERENCE

Item No.	Item	Unit/Display
1	Odometer	mile
2	Drive cycle	Count
4	Current trouble accumulative time	min
5	System power supply	V
7	Clutch pressure (Odd number gears)	mbar
8	Clutch pressure (Even number gears)	mbar
9	Clutch status (Odd number gears)	Inactive Closed (During the torque control) Hydraulic pressure charging Pre-stroke During hydraulic pressure relief Clutch not engaged Open Clutch in engagement Clutch in disengagement
10	Clutch status (Even number gears)	Inactive Closed (During the torque control) Hydraulic pressure charging Pre-stroke During hydraulic pressure relief Clutch not engaged Open Clutch in engagement Clutch in disengagement
11	Shift fork position sensor 1	mm
12	Shift fork position sensor 2	mm
13	Shift fork position sensor 3	mm
14	Shift fork position sensor 4	mm
15	Input shaft (odd) speed	r/min
16	Input shaft (even) speed	r/min
22	Current gear	N 1st 2nd 3rd 4th 5th 6th R N (Odd number) N (Even number) Undefined gear
23	Target gear	N 1st 2nd 3rd 4th 5th 6th R N (Odd number) N (Even number) Undefined gear
24	SST control mode	NORMAL SPORT
25	Gear change mode	AUTO Manual
26	Torque limit request (Fuel cut)	ON OFF
27	Torque limit request (Throttle closing)	ON OFF
28	Torque limit request (Retard)	ON OFF
30	Monitoring unit number (1)	Monitoring unit No. indication (Refer to DIAGNOSTIC TROUBLE CODE TABLE )
31	Monitoring unit number (2)
32	Monitoring unit number (3)
33	Monitoring unit number (4)
34	Monitoring unit number (5)
35	Monitoring unit number (6)
36	Monitoring unit number (7)
37	Monitoring unit number (8)
39	Vehicle speed	mph
40	Highside driver 1 state	ON OFF
41	Highside driver 2 state	ON OFF
42	Highside driver 3 state	ON OFF
43	Dumper speed sensor	r/min