LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2017 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Twin Clutch SPORTRONIC Shift Transmission (SST) Overhaul - Lancer) >> Transfer >> Disassembly And Assembly >> Assembly Service Point >> >> A << Cover Installation

>> A << Cover Installation

WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Completely degrease the FIPG-applied surface so that water and oil including the old sealant cannot adhere to the surface coated with the sealant.

    Never touch the degreased surface by hand.

  2. Apply a 1.5 mm (0.06 in) diameter bead of sealant as illustrated onto the cover.

    Specified sealant: Mitsubishi Part No. MD997740 or equivalent 

  3. Attach the cover to the transfer and tighten it to the specified torque.
    Fig 1: Identifying Sealant Applying Area On Cover
    G09626066Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals