LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2017 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Active Stability Control System (ASC) - With Diagnostics - Lancer) >> On-Vehicle Service >> Steering Wheel Sensor Calibration >> < Vehicles with TC-SST >

< Vehicles with TC-SST >

WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: After the next operation has been completed, carry out the following two operations:
  • Alignment adjustment < Front >
  • Steering wheel sensor (column switch assembly) replacement, removal, installation
  • ASC-ECU replacement
  1. Update the neutral position stored in the steering wheel sensor. 
  2. Reset the calibrated value of the steering angle stored in ASC-ECU. 
  3. Reset the calibrated value of the steering angle stored in AWC-ECU < Only when the steering wheel sensor (column switch assembly) is replaced, removed, or installed > 
    CAUTION:
    • Before performing the calibration, check if the steering wheel sensor-related diagnostic trouble code is set in ASC-ECU.
    • When the diagnostic trouble code other than C121A is set, carry out inspection according to each troubleshooting procedure.
scientia non olet · About LEMON Manuals