LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2017 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Active Stability Control System (ASC) - With Diagnostics - Lancer) >> On-Vehicle Service >> G And Yaw Rate Sensor Calibration >> < Vehicles with TC-SST (when the G and yaw rate sensor is replaced) >

< Vehicles with TC-SST (when the G and yaw rate sensor is replaced) >

WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Carry out steps  1 to  13 of the G and yaw rate sensor calibration for vehicles without TC-SST.
  2. Select the relevant system from the menu.
  3. Select "ACD/AYC" from the system lists in "System select", and press "OK" button.
  4. Select "Special function" in "ACD/AYC".
  5. Select "Sensor calibration" in "Special function".
  6. Select "Lateral G sensor calibration" from the selected item, and press "OK" button.
  7. The screen displays "Lateral G sensor calibration: The selected command will be executed. Are you sure? Caution: Please check the execution conditions." Then press "OK" button.
  8. "Execute: The command was executed." will be shown. Then press "OK" button.
  9. Select "Longitudinal G SNS. calibration" from the selected item, and press "OK" button.
  10. The screen displays "Longitudinal G SNS. calibration: The selected command will be executed. Are you sure? Caution: Please check execution conditions." Then press "OK" button.
  11. "Executed: The command was executed." will be shown. Then press "OK" button.
  12. Learning neutral point complete
  13. Turn the ignition switch to "LOCK" (OFF) position and then disconnect the scan tool.
scientia non olet · About LEMON Manuals