LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2017 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Active Stability Control System (ASC) - With Diagnostics - Lancer) >> Hydraulic Unit >> Removal And Installation >> Installation Service Point >> >> A << Brake Tube Connection

>> A << Brake Tube Connection

WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Install the brake pipe to the hydraulic unit as shown in the illustration.

  1. From master cylinder (primary) < Marking color: Blue >
  2. To front brake (RH) < Marking color: Orange and white >
  3. To front brake (LH) < Marking color: Red and white >
  4. From master cylinder (secondary) < Marking color: Yellow >
  5. To rear brake (RH) < Marking color: Pink >
  6. To rear brake (LH) < Marking color: White >
    Fig 1: Identifying Brake Tube Connections
    G05376438Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals