LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2017 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Active Stability Control System (ASC) - With Diagnostics - Lancer) >> Diagnosis >> Diagnostic Trouble Code Procedures >> DTC U0125: G and yaw rate sensor message time-out error/message error >> DTC Set Conditions

DTC Set Conditions

WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

This DTC is set when the ASC-ECU cannot receive the signal from the G and yaw rate sensor although there is no abnormality in ASC-ECU supply voltage.

NOTE: When an abnormality is present in the ASC-ECU supply voltage, DTC C2100 (low voltage error) is set, and DTC U0125 is not set.
scientia non olet · About LEMON Manuals