Exhaust Manifold Bracket Installation

WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Make sure that the exhaust manifold bracket is closely contacted with the exhaust manifold and transfer assembly, and then temporarily tighten the bolts.
Tighten bolt A on the exhaust manifold side in the illustration to the specified torque.
Tightening torque: 20 ± 5 N.m (15 ± 3 ft-lb)
Tighten bolt B on the transfer assembly side in the illustration to the specified torque.
Tightening torque: 20 ± 5 N.m (15 ± 3 ft-lb)

Fig 1: Removing/Installing Transfer Assembly Components With Torque Specification (AWD)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.