LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2017 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Continuously Variable Transaxle (CVT) Diagnosis & On-Vehicle Service - With Diagnostics - Lancer) >> On-Vehicle Service >> Essential Service >> Transfer Oil Check (AWD)

Transfer Oil Check (AWD)

WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the filler plug and gasket.
    Fig 1: Identifying Filler Plug And Gasket
    G07045854Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Check that the oil level is not 18 mm below the bottom of the oil filler plug hole.
  3. Check that the oil is not excessively foul and has moderate viscosity.
  4. If the oil level is not in between the upper limit and the lower limit, refill the specified oil to the bottom of the oil filler plug hole.

    Brand name: Mitsubishi Motors Genuine hypoid gear oil API classification GL-5 SAE 80 

    Fig 2: Identifying Transfer Oil
    G09626169Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  5. Install the filler plug and new gasket, and tighten to the specified torque.

    Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb) 

scientia non olet · About LEMON Manuals