Oscilloscope Inspection Procedures

WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

With the connector remain connected, connect the oscilloscope probe to each terminal of TCM.

Terminal No.	Check item	Check conditions	Normal conditions	Wave patterns
36 - 26	Secondary pulley rotation sensor	Transmission range: D Drive at a constant speed of Approximately 20 km/h (12 mph)	Between 0 and 4.5 V, the pulse cycle is constant.
37 - 26	Primary pulley rotation sensor		Between 0 and 4.5 V, the pulse cycle is constant.