LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2017 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (General Information - Lancer) >> Maintenance Service (2.0L Engine Non-Turbo, 2.4L Engine) >> Transaxle Oil < M/T > >> Check Oil Level And Condition >> Transaxle Oil Level Check

Transaxle Oil Level Check

WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the filler plug and gasket.
  2. Check that the oil level is up to the lower edge of the filler plug hole.
  3. Check that the oil is not noticeably dirty.
  4. Tighten the filler plug and new gasket, to the specified torque.

    Tightening torque: 49 ± 19 N.m (37 ± 14 ft-lb) 

    Fig 1: Identifying Filler And Drain Plug
    G05374019Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 2: Identifying Filler Plug Hole, Gasket And Filler Plug
    G06672032Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals