LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> RVR ES >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Continuously Variable Transaxle (CVT) On-Vehicle Service - With Diagnostics) >> On-Vehicle Service >> CVT Control Component Check >> Selector Lever Operation Check

Selector Lever Operation Check

WARNING: This page is about a different variant/trim than selected.
  1. Put on the parking brake.
  2. Move the selector lever to every range and check that the lever moves smoothly with secure feel of engagement.
  3. Make sure that the engine starts when the selector lever is in the N or P range, and does not start when the selector lever is in other range.
  4. Start the engine. Release the parking brake.
  5. Make sure that the vehicle moves forward when the selector lever is moved from the N range to D range, or to the 1st to 6th speed in the sports mode. Also make sure that the vehicle moves backward when the selector lever is moved from the N to R range.
  6. Stop the engine.
  7. Turn ON the ignition switch, and move the selector lever from the P to R range. Check that the backup lamp comes on and the tone alarm sounds at this time.
    NOTE: Since the vehicle is equipped with the CVT wrong-operation preventive device, the selector lever cannot be moved out of the P position without depressing the brake pedal after turning ON the ignition switch.
    Fig 1: Selector Lever Operation Inspection
    G09669731Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals