Trouble Symptom Chart
WARNING: This page is about a different variant/trim than selected.
CAUTION:
During diagnosis, a diagnostic trouble code associated with other system may be set when the ignition switch is turned on with connector(s) disconnected. On completion, confirm all systems for diagnostic trouble code(s). If diagnostic trouble code(s) are set, erase them all.
| Trouble symptom | Inspection procedure number | Reference |
|---|---|---|
| TCM cannot communicate with scan tool. | 1 | Inspection Procedure 1: TCM cannot communication with scan tool |
| VEHICLE CREEPS IN THE N RANGE. | 2 | Inspection Procedure 2: Vehicle Creeps in the N Range |
| SHOCK IS EXPERIENCED DURING N TO D AND/OR N TO R SHIFTING OPERATION. | 3 | Inspection Procedure 3: Shock is experienced during N to D and/or N to R shifting operation |
| POOR ACCELERATION OR INCOMPLETE SHIFTING OPERATION. | 4 | Inspection Procedure 4: Poor Acceleration or Incomplete Shifting Operation |
| CANNOT BE CHANGED IN SPORT MODE. | 5 | Inspection Procedure 5: Cannot be Changed in Sport Mode |
| CANNOT BE CHANGED WITH PADDLE SHIFT. < VEHICLES WITH PADDLE SHIFT > | 6 | Inspection Procedure 6: Cannot be Changed with the Paddle Shift. < Vehicles with paddle shift > |
| THE FLUID TEMPERATURE WARNING LAMP ILLUMINATES TOO FREQUENTLY. | 7 | Inspection Procedure 7: The fluid temperature warning lamp illuminates too frequently |