Inspection Procedure 3: Any of the sunshade illuminations does not illuminate normally: Diagnosis

Check if the sunshade illumination turns ON normally.

Q: Is the check result normal? 

• YES (normal for all):  The diagnosis is complete.
• NO (Only the RH side does not illuminate.):  Go to Step 2.
• NO (Only the LH side does not illuminate.):  Go to  Step 4.

Q: Is sunshade illumination (RH) connector E-10 and the intermediate connector E-14 in good condition? 

• YES:  Go to Step 3.
• NO:  Repair or replace the damaged component(s). Refer to HARNESS CONNECTOR INSPECTION .

• Check the power supply lines and ground wires for open and short circuit.

Q: Is the wiring harness between sunshade illumination (RH) connector E-10 terminal No. 1/2 and the intermediate connector E-14 terminal No. 3/4 in good condition? 

• YES:  Go to  Step 6.
• NO:  The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the connector. Repair the wiring harness as necessary.

Q: Is sunshade illumination (LH) connector E-13 and the intermediate connector E-14 in good condition? 

• YES:  Go to Step 5.
• NO:  Repair or replace the damaged component(s). Refer to HARNESS CONNECTOR INSPECTION .

• Check the power supply lines and ground wires for open and short circuit.

Q: Is the wiring harness between sunshade illumination (LH) connector E-13 terminal No. 1/2 and the intermediate connector E-14 terminal No. 3/4 in good condition? 

• YES:  Go to Step 6.
• NO:  The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the connector. Repair the wiring harness as necessary.

Check if the sunshade illumination turns ON normally.

Q: Is the check result normal? 

• YES:  The trouble can be an intermittent malfunction (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION ).
• NO:  Replace the spot light assembly that does not illuminate.