Learning Procedures Of The Sunshade Fully Closed Position: Notes

Shifting conditions for the fully closed position adjustment mode 

• When shifting to the forced fully closed position adjustment mode

  How to shift to the forced fully closed position adjustment mode

  1. Turn the ignition switch to the "ON" position.
  2. Press and hold the close switch for 10 seconds when the sunshade lid is fully closed.
• When the position information may be incorrect due to abnormal power supply during the sunshade operation
  NOTE: When installing the sunshade assembly, or installing/replacing the sunshade motor assembly, operate the forced fully closed position adjustment mode to adjust the fully closed position.