LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Twin Clutch SPORTRONIC Shift Transmission (TC-SST) - With Diagnostics - Lancer (5 Of 6)) >> Diagnosis < Active Center Differential (ACD) > >> Diagnostic Trouble Code Procedures >> DTC C1219: Steering Wheel Sensor System (Faulty Signal) >> Diagnosis

DTC C1219: Steering Wheel Sensor System (Faulty Signal): Diagnosis

WARNING: This page is about a different variant/trim than selected.
  1. STEP 1. Scan tool CAN bus diagnostics 

    Using scan tool MB991958, diagnose the CAN bus lines.

    Q: Is the check result normal? 

    1. YES:  Go to  Step 3.
    2. NO:  Repair the CAN bus lines. (Refer to TROUBLESHOOTING ). After repairing the CAN bus line, go to Step 2.
  2. STEP 2. Check whether the DTC is reset. 

    Q: Is DTC No. C1219 set? 

    1. YES:  Go to Step 3.
    2. NO:  This diagnosis is complete.
  3. STEP 3. Scan tool diagnostic trouble code 

    Q: Is DTC No. C2205 set? 

    1. YES:  Perform the relevant troubleshooting.
    2. NO:  Go to Step 4.
  4. STEP 4. Scan tool diagnostic trouble code 

    Check if the wheel speed sensor-related, G and yaw rate sensor-related, or steering wheel sensor-related diagnostic trouble code is set.

    Q: Is the DTC set? 

    1. YES:  Carry out the appropriate troubleshooting. Then go to  Step 9.
    2. NO:  Go to Step 5.
  5. STEP 5. Check of steering wheel sensor installation status 

    Check that the steering wheel sensor is installed correctly. (Refer to STEERING WHEEL SENSOR ).

    Q: Is the check result normal? 

    1. YES:  Go to Step 6.
    2. NO:  Install the steering wheel sensor correctly. Then go to Step 6.
  6. STEP 6. Wheel alignment check 

    Q: Is the check result normal? 

    1. YES:  After checking the wheel alignment, calibrate the steering wheel sensor (Refer to STEERING WHEEL SENSOR CALIBRATION ), and initialize AWC-ECU steering angle correction amount (Refer to SPECIAL FUNCTION REFERENCE TABLE  ). Then, go to Step 7.
    2. NO:  After adjusting the wheel alignment, calibrate the steering wheel sensor (Refer to STEERING WHEEL SENSOR CALIBRATION ), and initialize AWC-ECU steering angle correction amount (Refer to SPECIAL FUNCTION REFERENCE TABLE  ). Then, go to Step 7.
  7. STEP 7. Scan tool data list 

    Item 11: Steering wheel sensor (Refer to DATA LIST REFERENCE TABLE  ).

    Q: Is the check result normal? 

    1. YES:  Go to Step 8.
    2. NO:  Replace the steering wheel sensor. (Refer to STEERING WHEEL SENSOR ). Then, go to  Step 9.
  8. STEP 8. Check whether the DTC is reset. 

    Q: Is DTC No. C1219 set? 

    1. YES:  Replace the AWC-ECU. (Refer to AWC-ECU ). Then, go to Step 9.
    2. NO:  Intermittent malfunction. (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION ).
  9. STEP 9. Check whether the DTC is reset. 

    Q: Is DTC No. C1219 set? 

    1. YES:  Return to  Step 1.
    2. NO:  This diagnosis is complete.
scientia non olet · About LEMON Manuals