<< B >> Fuel High-Pressure Hose Disconnection
WARNING: This page is about a different variant/trim than selected.
- Follow the steps below to unlock the fuel high-pressure hose connector.
- Insert a flat-tipped screwdriver [6 mm (0.24 inch) wide and 1 mm (0.04inch) thick] into the retainer of the fuel high-pressure hose connector.
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
CAUTION: When pushing up the retainer of the fuel high-pressure hose connector, pay attention to avoid damage to the retainer. - Turn the flat-tipped screwdriver inserted into the retainer by 90 degrees angle to push up the retainer and unlock the fuel high-pressure hose connector.
- Insert a flat-tipped screwdriver [6 mm (0.24 inch) wide and 1 mm (0.04inch) thick] into the retainer of the fuel high-pressure hose connector.
- Disconnect the fuel high-pressure hose.