LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 2.0L Turbo - Lancer) >> Crankshaft Oil Seal >> Removal And Installation >> Installation Service Points >> >> A << Crankshaft Rear Oil Seal Case Assembly Installation

>> A << Crankshaft Rear Oil Seal Case Assembly Installation

WARNING: This page is about a different variant/trim than selected.
  1. Remove all the traces of sealant adhering to the cylinder block and ladder frame using a remover or others. Then, degrease them using.
  2. Apply the sealant without any gap to the cylinder block and ladder frame as shown in the figure, and install the crankshaft rear oil seal case assembly.

    Specified sealant: ThreeBond 1227D or equivalent 

    NOTE: Install the crankshaft rear oil seal case assembly immediately after applying sealant.
  3. Apply a small amount of engine oil to the entire inner diameter of the crankshaft rear oil seal lip, and install the crankshaft rear oil seal case assembly.
    CAUTION: After the installation, until a sufficient period of time (one hour or more) elapses, do not apply the engine oil or water to the sealant application area or start the engine.
  4. Tighten the crankshaft rear oil seal case assembly mounting bolts to the specified torque.

    Tightening torque: 10 ± 2 N.m (89 ± 17 in-lb) 

    Fig 1: Identifying Crankshaft Rear Oil Seal Case Sealant Application Area
    G05392434Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals