Inspection Procedure 3: The headlights (low-beam) illuminate regardless of the lighting switch positions. (High-beam does not illuminate): Notes
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Before replacing the ECU, ensure that the power supply circuit, the ground circuit and the communication circuit are normal.
- When the ETACS-ECU of vehicles without KOS is replaced, the encrypted code of the ignition key needs to be registered to the ETACS-ECU. (If the encrypted code is not registered, the engine cannot be started. Register the encrypted code as described in Immobilizer System - HOW TO REGISTER KEY ID )
- When the LDW-ECU is replaced, always initialize the LDW camera (Refer to ON-VEHICLE SERVICE ) and adjust the LDW camera image (Refer to HOW TO RESET THE LDW CAMERA INITIALIZATION DATA ).