<< A >> Parking Brake Rear Cable Connection Removal < Rear Brake Caliper Assembly Side >

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

Compress the tabs on the cable retainer to pull out the parking rear cable through the parking lever hole of the rear brake caliper assembly.

NOTE:

When pulling out the parking rear cable, be careful not to damage the tab on the cable retainer.

Fig 1: Compressing Tabs On Cable Retainer
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Example: Insert the 12.8-mm hose clip (MB248923) into the parking rear cable. Then push the clip over the cable retainer to protect the tabs.

Fig 2: Inserting Hose Clip Into Parking Rear Cable
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.