Code No. C2206 Re-execution of variant coding: Diagnosis

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

STEP 1. Scan tool (M.U.T.-III) CAN bus diagnostics
Use scan tool (M.U.T.-III) to diagnose the CAN bus lines.

Q: Is the check result normal?
1. YES: Go to Step 2.
2. NO: Repair the CAN bus lines (Refer to CAN BUS DIAGNOSTICS TABLE ). On completion, go to Step 6.
STEP 2. Scan tool (M.U.T.-III) DTC of other system
Use scan tool (M.U.T.-III) to check that the vehicles information-related DTC is stored in the ETACS-ECU.

Q: Is the DTC stored?
1. YES: Troubleshoot the relevant DTC, and then go to Step 3.
2. NO: Go to Step 5.
STEP 3. ETACS-ECU coding data check
Refer to CODING LIST .

Q: Is the check result normal?
1. YES: Go to Step 5.
2. NO: Go to Step 4.
STEP 4. ETACS-ECU variant coding
Perform the variant coding to the ETACS-ECU.

Q: Does variant coding succeed?
1. YES: Go to Step 6.
2. NO: Replace the ETACS-ECU (Refer to ETACS-ECU ), and then go to Step 6.
STEP 5. Check whether the DTC is stored again.
1. Erase the DTC.
2. Ignition switch "LOCK" (OFF)
3. Ignition switch "ON"
Q: Is DTC No. C2206 stored?
1. YES: Replace the hydraulic unit (integrated with ASC-ECU) (Refer to HYDRAULIC UNIT ). Then go to Step 6.
2. NO: This diagnosis is complete.
STEP 6. Check whether the DTC is stored again.
1. Erase the DTC.
2. Ignition switch "LOCK" (OFF)
3. Ignition switch "ON"
Q: Is DTC No. C2206 stored?
1. YES: Return to Step 1.
2. NO: This diagnosis is complete.