Inspection Procedure 17: The starter does not rotate at the "P" or "N" range. (The engine does not start.): Diagnosis
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- STEP 1. Check the engine performance.
Q: Is the check result normal?
- YES: Go to Step 2.
- NO: Repair the failure, and perform adjustment.
- STEP 2. Check the transaxle control cable.
Check the installation of the transaxle control cable.
Q: Is the check result normal?
- YES: Go to Step 3.
- NO: Adjust the transaxle control cable TRANSMISSION RANGE SWITCH AND CONTROL CABLE ADJUSTMENT .
- STEP 3. Check and adjust the transmission range switch.
Refer to TRANSMISSION RANGE SWITCH CHECK .
If the transmission range switch has a failure, replace it, and then check the trouble symptom again.
Q: Is the check result normal?
- YES: The procedure is complete.
- NO: Go to Step 4.
- STEP 4. Check the electric system.
Check the starter-related wiring for poor insertion of connector or open circuit.
Q: Is the check result normal?
- YES: Replace the TCM.
- NO: Repair the failure, and perform adjustment.