Inspection Procedure 11: The select shock is large when the selector lever position is shifted from "N" to "D", and "N" to "R.": Diagnosis
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- STEP 1. Check the engine performance.
Especially check that the idle speed does not exceed the specified value.
Q: Is the check result normal?
- YES: Go to Step 2.
- NO: Repair the failure, and perform adjustment.
- STEP 2. Check and adjust the transmission range switch.
Refer to TRANSMISSION RANGE SWITCH CHECK TRANSMISSION RANGE SWITCH AND CONTROL CABLE ADJUSTMENT .
If the transmission range switch has a failure, replace it, and then check the trouble symptom again.
Q: Is the check result normal?
- YES: The procedure is complete.
- NO: Go to Step 3.
- STEP 3. Replace the TCM.
Q: Is the failure resolved?
- YES: The procedure is complete.
- NO: Go to Step 4.
- STEP 4. Compare with another same model vehicle.
Q: Is there a difference from the same model vehicle?
- YES: Go to Step 5.
- NO: The procedure is complete.
- STEP 5. Remove the transaxle assembly from the vehicle.
Disassemble and check the transaxle assembly to check if there is a foreign material inside.
Q: Is the check result satisfactory?
- YES: Replace the transaxle assembly.
- NO: Replace the failure part.