LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Automatic Transaxle On-Vehicle Service - With Diagnostics) >> Automatic Transaxle Diagnosis < A/T > >> Diagnostic Trouble Code Procedures >> DTC P1706: Accelerator Pedal Position Sensor Information >> Diagnosis

DTC P1706: Accelerator Pedal Position Sensor Information: Diagnosis

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. STEP 1. Is the DTC for ECM displayed? 

    Check that the failure related to the engine does not occur.

    Q: Is the check result normal? 

    • YES:  Go to Step 2.
    • NO:  Repair or replace the failure section.
  2. STEP 2. Check the accelerator pedal position sensor and ECM side main unit and connector wiring. 

    Q: Is the check result normal? 

    • YES:  Go to Step 3.
    • NO:  Repair or replace the failure section.
  3. STEP 3. Erase the DTC, and drive the vehicle for a while. 

    Check that the normal code is displayed.

    Q: Is the check result normal? 

    • YES:  The procedure is complete.
    • NO:  Return to  Step 1.
scientia non olet · About LEMON Manuals