LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Continuously Variable Transaxle (CVT) On-Vehicle Service - With Diagnostics) >> Diagnosis < CVT > >> Symptom Procedures >> INSPECTION PROCEDURE 3: Shock is Experienced During N to D and/or N to R Shifting Operation >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. STEP 1. Engine idling speed check 

    Q: Is the check result normal? 

    1. YES:  Go to Step 2.
    2. NO:  Refer to the ENGINE DIAGNOSIS
  2. STEP 2. Line pressure check 

    Carry out "hydraulic test" (Refer to HYDRAULIC PRESSURE TEST  ).

    Q: Is the check result normal? 

    1. YES:  Go to Step 3.
    2. NO:  Repair according to the hydraulic pressure diagnosis table.
  3. STEP 3. Retest the system. 
    • Replace TCM.
    • Recheck the trouble symptom.

    Q: Does the malfunction take place again? 

    1. YES:  Replace the CVT assembly.
    2. NO:  The inspection is complete.
scientia non olet · About LEMON Manuals