LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Engine Overhaul - 2.4L) >> Water Hose And Pipe >> Removal And Installation >> Installation Service Points >> >> C << Engine Coolant Temperature Sensor Installation

>> C << Engine Coolant Temperature Sensor Installation

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Be careful not to give a shock, twist and the like to the resin mould with a tool during installation.
  1. Apply an appropriate and minimum amount of sealant to the coolant temperature sensor, taking care not to allow sealant to squeeze out.

    Specified sealant: ThreeBond 1324N or equivalent 

  2. Tighten the coolant temperature sensor to the cylinder block to the specified torque of 30 ± 9 N.m (22 ± 6 ft-lb).
    Fig 1: Identifying Engine Coolant Temperature Sensor Sealant Applying Area
    G09663474Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals