>> C << O-Ring/Crank Angle Sensor Installation
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Do not apply a force such as torsion or twist to the O-ring during assembly of the sensor.
- Apply liquid gasket to the illustrated area of the crank angle sensor.
Specified sealant: ThreeBond 1207D or equivalent
- Tighten the crank angle sensor installation bolt to the specified torque.
Tightening torque: 11 ± 1 N.m (97 ± 8 in-lb)