LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Engine Cooling System) >> Water Hose And Water Pipe >> Removal And Installation < 3. 0 L Engine > >> Installation Service Points >> >> C << Engine Coolant Temperature Sensor Installation

>> C << Engine Coolant Temperature Sensor Installation

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply the specified sealant to the thread of the engine coolant temperature sensor.

    Specified Sealant: ThreeBond 1324N or equivalent 

    Fig 1: Locating Engine Coolant Temperature Sensor Sealant Applying Area
    G09664646
  2. Use special tool water temp sensor wrench (MB992042) to tighten the engine coolant temperature sensor to the specified torque.

    Tightening torque: 30 ± 9 N.m (22 ± 6 ft-lb) 

    Fig 2: Installing Engine Coolant Temperature Sensor Using Special Tool (MB992042)
    G09664647
scientia non olet · About LEMON Manuals