>> B << Drive Plate/Drive Plate Adapter Plate/Drive Plate Bolt Installation
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the sealant, engine oil, and other adhering materials from the drive plate installation face, the crankshaft screw hole and drive plate bolts.
- Install the drive plate and drive plate adapter plate to the crankshaft.
- Fix the drive plate using special tool flywheel stopper (MB991883) in the same manner as removal.
- Apply the engine oil to the installation face of the drive plate bolts for the drive plate.
- Apply specified sealant to the drive plate bolts threads.
Specified sealant: ThreeBond 1324 or equivalent
- Tighten the drive plate bolts to the specified torque in the order shown in the illustration.
Tightening torque: 40 N.m (30 ft-lb)
- Tighten the drive plate bolts to the specified torque again in the order shown in the illustration.
Tightening torque: 130 N.m (96 ft-lb)