LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Intake & Exhaust System) >> Exhaust Manifold >> Removal And Installation - 2.4L Engine >> Removal Service Point >> << A >> Heated Oxygen Sensor Removal

<< A >> Heated Oxygen Sensor Removal

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the heated oxygen sensor connector connection and clamp.
  2. Use special tool heated oxygen sensor wrench (MB991953) to remove the heated oxygen sensor.
    Fig 1: Removing/Installing Heated Oxygen Sensor Using Special Tool
    G09664671Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals