LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Intake & Exhaust System) >> Exhaust Manifold >> Removal And Installation - 2.4L Engine >> Installation Service Points >> >> C << Heated Oxygen Sensor Installation

>> C << Heated Oxygen Sensor Installation

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. In the same manner as removal, use special tool heated oxygen sensor wrench (MB991953) to tighten the heated oxygen sensor to the specified torque.

    Tightening torque: 44 ± 5 N.m (32 ± 3 ft-lb) 

  2. Install the heated oxygen sensor connector connection and clamp.
    Fig 1: Removing/Installing Heated Oxygen Sensor Using Special Tool
    G09664673Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals