DTC B1761: VIN not programmed: Diagnosis

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

STEP 1. Using scan tool (M.U.T.-III), diagnose the CAN bus line.
CAUTION: To prevent damage to scan tool (M.U.T.-III), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-III).
1. Connect scan tool (M.U.T.-III). Refer to "HOW TO CONNECT THE SCAN TOOL (M.U.T.-III) ."
2. Erase the DTC.
3. Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
4. If no chassis number is stored in the ETACS-ECU, check whether a chassis number is stored in the engine control module. (Refer to DTC P0630: VEHICLE IDENTIFICATION NUMBER (VIN) MALFUNCTION ).
5. Check if DTC is stored.
Q: Is the DTC stored?
1. YES: Replace the ETACS-ECU.
2. NO: The diagnosis is complete.