LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (MULTIPORT Fuel Injection (MFI) - 2.4L (1 Of 6)) >> Service Specification(S)

Service Specification(S)

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
ITEMS STANDARD VALUE
Fuel pressure kPa (psi) Approximately 324 (47) at curb idle
Intake air temperature sensor resistance kΩ -20°C (-4°F) 13 - 18
0°C (32°F) 5.3 - 6.7
20°C (68°F) 2.3 - 3.0
80°C (176°F) 0.30 - 0.45
Engine coolant temperature sensor resistance kΩ -20°C (-4°F) 14 - 17
20°C (68°F) 2.1 - 2.7
80°C (176°F) 0.26 - 0.36
Heated oxygen sensor output voltage V 0.6 - 1.0
Linear air-fuel ratio sensor heater resistance Ω 2.3 - 4.2 [at 20°C (68°F)]
Heated oxygen sensor (rear) heater resistance Ω 4.5 - 8.0 [at 20°C (68°F)]
Injector coil resistance Ω 10.5 - 13.5 [at 20°C (68°F)]
Throttle actuator control motor coil resistance Ω 0.3 - 100 [at 20°C (68°F)]
Oil feeder control valve coil resistance Ω 6.9 - 7.9 [at 20°C (68°F)]