LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (MULTIPORT Fuel Injection (MFI) - 3.0L - Introduction (1 Of 2)) >> Special Tool

Special Tool

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
Tool Tool number and name Supersession Application
G09664243Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
MB992080
  1. MB9912081 Belt tension meter
  2. MB992082 Microphone assembly
Tool not available Drive belt tension (frequency) measurement
G09664244Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  1. MB992744 Vehicle communication interface-Lite (V.C.I.-Lite)
  2. MB992745 V.C.I.-Lite main harness A (for vehicles with CAN communication)
  3. MB992746 V.C.I.-Lite main harness B (for vehicles without CAN communication)
  4. MB992747 V.C.I.-Lite USB cable short
  5. MB992748 V.C.I.-Lite USB cable long
-
  • Standard ignition timing check
  • Idle speed check
  • Reading diagnostic trouble code
  • MFI system inspection
  • Measurement of fuel pressure
G09664245Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
MB991958
Scan tool (M.U.T.-III sub assembly)
  1. MB991824 Vehicle communication interface (V.C.I.)
  2. MB991827 M.U.T.-III USB cable
  3. MB991910 M.U.T.-III main harness A (Vehicles with CAN communication system)
  4. MB991911 M.U.T.-III main harness B (Vehicles without CAN communication system)
  5. MB991914 M.U.T.-III main harness C (for Daimler Chrysler models only)
  6. MB991825 M.U.T.-III adapter harness
  7. MB991826 M.U.T.-III trigger harness
MB991824-KIT
NOTE: MB991826 M.U.T.-III Trigger Harness is not necessary when pushing V.C.I. ENTER key.
CAUTION: For vehicles with CAN communication, use M.U.T.-III main harness A to send simulated vehicle speed. If you connect M.U.T.-III main harness B instead, the CAN communication does not function correctly.
  • Reading diagnostic trouble code
  • MFI system inspection
  • Measurement of fuel pressure
G09664246Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
MB992110
Power plant ECU check harness
-
  • Inspection using an oscilloscope
  • Inspection of the engine control module (ECM) terminal voltage check
G09664247Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
MB991709
Test harness
MB991709-01 Inspection using an oscilloscope
G09664248Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
MB991658
Test harness
Tool not available
  • Inspection using an oscilloscope
  • Inspection of heated oxygen sensor
  • Inspection of engine oil control valve
G09664249Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
MD998464
Test harness (4 pin, square)
MD998464-01 Inspection of heated oxygen sensor
G09664250Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
MB991316
Test harness (4 pin, square)
Tool not available Inspection of heated oxygen sensor
G09664251Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
MB992049 MB992049-01 Measurement of fuel pressure
G09664252Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
MB992001
Hose adaptor
- Measurement of fuel pressure
G09664253Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
MB991981
Fuel pressure gauge set
Tool not available Measurement of fuel pressure
G09664254Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
MB992076
Injector test set
- Measurement of fuel pressure
G09664255Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
MD998709 Hose adapter Measurement of fuel pressure
G09664256Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
MB992106
O-ring installer
- Installation of O-ring on fuel injector injection nozzle side