LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer GT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 2.0L Turbo - Lancer) >> Cylinder Head Gasket >> Removal And Installation >> >> C << Camshaft Bearing/Camshaft And Camshaft Sprocket Assembly Installation >> >> G << Fuel High-Pressure Hose Connection

>> G << Fuel High-Pressure Hose Connection

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • When pushing in the retainer of the fuel high-pressure hose connector, pay attention to avoid damage to the retainer.
  • After the installation of the fuel high-pressure hose, slightly pull the fuel high-pressure hose to check that it is connected securely. At this time, also check that there is approximately 1 mm (0.04inch) play.
  1. Securely insert the fuel rail stopper into the fuel high-pressure hose connector groove to install the fuel high-pressure hose to the fuel rail.
  2. Push in the retainer of the fuel high-pressure hose connector to lock the fuel high-pressure hose and fuel rail.
    Fig 1: Inserting Fuel Rail Stopper Into Fuel High-Pressure Hose Connector Groove
    G05375313Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals