Code No. C1210 Longitudinal G sensor input circuit: Diagnosis

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

STEP 1. Scan tool (M.U.T.-III) CAN bus diagnosis
Use scan tool (M.U.T.-III) to diagnose the CAN bus lines.

Q: Is the check result normal?
1. YES: Go to Step 3.
2. NO: Repair the CAN bus lines (Refer to CAN BUS DIAGNOSTICS TABLE ). On completion, go to Step 2.
STEP 2. DTC recheck after resetting CAN bus lines
Q: Is DTC No. C1210 stored?
1. YES: Go to Step 3.
2. NO: This diagnosis is complete.
STEP 3. Scan tool (M.U.T.-III) data list
Check the following data list (Refer to DATA LIST REFERENCE TABLE ).
- Item 09: G sensor
Q: Is the check result normal?
1. YES: Go to Step 4.
2. NO: Replace the hydraulic unit (integrated with ASC-ECU) (Refer to HYDRAULIC UNIT ). Then go to Step 5.
STEP 4. Check whether the DTC is stored again.
Erase the DTC.

Q: Is DTC No. C1210 stored?
1. YES: Replace the hydraulic unit (integrated with ASC-ECU) (Refer to HYDRAULIC UNIT ), and then go to Step 5.
2. NO: Intermittent malfunction (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTIONS ).
STEP 5. Check whether the DTC is stored again.
Erase the DTC.

Q: Is DTC No. C1210 stored?
1. YES: Return to Step 1.
2. NO: This diagnosis is complete.