LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer GT >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Engine Cooling System) >> Thermostat >> Removal And Installation < 2. 4 L Engine > >> Removal Service Point >> << A >> Hose Clip/Radiator Lower Hose Disconnection

<< A >> Hose Clip/Radiator Lower Hose Disconnection

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make mating marks on the radiator hose and the hose clamp as shown to install them in the original position. Then, remove them.
    Fig 1: Identifying Radiator Hose And Hose Clamp Mating Mark
    G09664620
    Fig 2: Identifying Radiator Hose Clip And Claw
    G09664621
  2. Break off the tip of hose clip claw and spread out the hose clip.
    NOTE: If there is a hose clip claw, the hose clip cannot spread to capacity because the claw contacts the hose clip.
  3. Disconnect the radiator lower hose.
scientia non olet · About LEMON Manuals