LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer GT >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Engine Mechanical - 2.4L) >> Crankshaft Oil Seal >> Removal And Installation >> Installation Service Points >> >> C << Crankshaft Front Oil Seal Installation

>> C << Crankshaft Front Oil Seal Installation

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply a small amount of engine oil to the entire inner diameter of the crankshaft front oil seal lip.
    CAUTION: When installing the crankshaft front oil seal, be careful to avoid damage to the crankshaft front oil seal.
  2. Using special tool bush remover and installer base (MB991448), press in the crankshaft front oil seal up to the chamfered surface of timing chain case.
    Fig 1: Pressing Crankshaft Front Oil Seal Using Tool
    G09663383
scientia non olet · About LEMON Manuals