LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer GT >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Supplemental Restraint System (SRS) - With Diagnostics) >> Seat Belts With Pre-TENSIONER >> Removal And Installation >> Removal Service Points >> << B >> Seat Belt Pre-TENSIONER Removal

<< B >> Seat Belt Pre-TENSIONER Removal

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When discarding the seat belt with pre-tensioner, discard after operating the seat belt pre-tensioner as specified in the service procedure (Refer to SEAT BELT PRE-TENSIONER DISPOSAL PROCEDURES  ).
  1. Use the flat-tipped screwdriver to pull out the locking button of wiring harness side connector, and release the lock.
    Fig 1: Pulling Out Locking Button Of Harness Connector
    G09666795Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 2: Pulling Out Harness Side Connector Locking Button
    G09666796Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals