LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Continuously Variable Transaxle (CVT) Diagnosis & On-Vehicle Service - With Diagnostics - Lancer >> Diagnosis >> Diagnostic Trouble Code Procedures >> DTC P0882: Malfunction of power supply system (Low); DTC P0883: Malfunction of power supply system (high) >> Diagnostic Procedure

Diagnostic Procedure

  1. STEP 1. Check the following connector: 
    • A-15X CVT control relay connector
    • C-41 TCM connector

    Check each terminal for imperfect contact.

    Q: Is the check result normal? 

    1. YES:  Go to Step 2.
    2. NO:  Repair the defective connector.
  2. STEP 2. Check for short circuit in the wiring harness between the fusible link No. 36 and the TCM connector. 
    • Between fusible link No. 36 and C-41 TCM connector (terminal No. 12)
    • Between fusible link No. 36 and C-41 TCM connector (terminal No. 25)

    Q: Is the check result normal? 

    1. YES:  Go to Step 3.
    2. NO:  Repair the wiring harness.
  3. STEP 3. Check for open circuit in the wiring harness between the TCM connector and the ground. 
    • Between C-41 TCM (terminal No. 13) and ground
    • Between C-41 TCM (terminal No. 26) and ground

    Q: Is the check result normal? 

    1. YES:  Go to Step 4.
    2. NO:  Repair the wiring harness.
  4. STEP 4. Retest the system. 

    Recheck the trouble symptom.

    Q: Does the malfunction take place again? 

    1. YES:  Replace TCM.
    2. NO:  Intermittent malfunction
scientia non olet · About LEMON Manuals