Rear Wheel Alignment Check And Adjustment: Camber

Standard value: -0°55' ±0°30' (Difference between right and left wheels must be 0°30' or less.)

NOTE:

For FWD vehicles with aluminum wheels, attach the camber/caster/kingpin gauge by using a compensator.

Fig 1: Attaching Camber/Caster/Kingpin Gauge Using Compensator
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
For AWD vehicles with aluminum wheels, tighten the wheel alignment gauge attachment (Special tool: MB991004) to the specified torque, then measure the camber.
The camber is pre-adjusted at factory and is not adjustable.

Fig 2: Tightening Wheel Alignment Gauge Attachment Tool

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.