Camber, Caster And Kingpin Inclination
Required Special Tool:
- MB991004: Wheel Alignment Gauge Attachment
< Vehicles with aluminum wheels >
Standard value:
Camber: -0°05' ± 0°30' (Difference between right and left wheels must be 0°30' or less.)
Caster: 2°40' ± 0°30' (Difference between right and left wheels must be 0°30' or less.)
Kingpin inclination: 13°30' ± 1°30'
NOTE:
Camber and caster are preset at the factory and cannot be adjusted.
CAUTION:
Never subject the wheel bearings to the vehicle load when the drive shaft nuts are loosened.
NOTE:
For vehicles with aluminum type wheels, attach the camber/caster/kingpin gauge to the driveshaft by using the special tool MB991004. Tighten the special tool MB991004 to the same torque 144 - 176 N.m (106 - 130 ft-lb) as the driveshaft nut.