Special Tools
| Tool | Tool number and name | Supersession | Application |
|---|---|---|---|
MB991958
M.U.T.-III sub-assembly
|
MB991824-KIT
NOTE:
G: MB991826 M.U.T.-III Trigger Harness is not necessary when pushing V.C.I. ENTER key.
|
CAUTION:
M.U.T.-III main harness A (MB991910) should be used. M.U.T.-III main harness B and C should not be used for this vehicle. Electrical power steering-ECU check (Diagnostic trouble code, data list) |
|
MB991223
Harness set
|
General service tools | Continuity check and voltage measurement at harness wire or connector for loose, corroded or damaged terminals, or terminals pushed back in the connector.
|
|
| MB992006 Extra fine probe |
- | Making voltage and resistance measurement during troubleshooting | |
| MB991897 or MB992011 Ball joint remover |
MB991113-01, MB990635-01 or General service tool | Knuckle and tie rod end ball joint disconnection
NOTE:
Steering linkage puller (MB990635 or MB991113) is also available to disconnect knuckle and tie rod end ball joint.
|
|
| MB990326 Preload socket |
General service tool | Tie rod end ball joint breakaway torque check | |
| MB990784 Ornament remover |
General service tool | Cover removal | |
| MB990228 or MB991006 Preload socket |
MB990228-01 | Steering gear total pinion torque check | |
| MB990803 Steering wheel puller |
General service tool | Steering wheel removal | |
| MB992209 Bellows band crimping tool |
MB992209 | Bellows band installation | |
| MB992908 Bellows band crimping tool |
MB992908 | ||
| MB992249 Variable spanner |
MB992249 | Tie-rod removal and installation | |
| MB990776 Front axle base |
MB990776-01 | Dust cover installation |