Inspection procedure 3: The SRS Warning Light does not Illuminate: Diagnosis

Required Special Tools:

MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: Vehicle Communication Interface (V.C.I.)
- MB991827: M.U.T.-III USB Cable
- MB991910: M.U.T.-III Main Harness A (Vehicles with CAN communication system)

STEP 1. Using scan tool MB991958, diagnose the CAN bus line.
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.

Use scan tool MB991958 to diagnose the CAN bus lines.
1. Connect scan tool MB991958 to the data link connector.
2. Turn the ignition switch to the "ON" position.
3. Diagnose the CAN bus line.
Q: Is the check result satisfactory?
- YES: Go to Step 2.
- NO: Repair the CAN bus line (Refer to DIAGNOSIS ).
  
  Fig 1: Connecting Special Tool MB991910 To Data Link Connector
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
STEP 2. Using scan tool MB991958, check actuator test
Check the SRS-ECU actuator tests. Item No. 01: SRS warning light

Q: Does the SRS warning light turn on and off normally?
- YES: Go to Step 3.
- NO: Replace SRS-ECU (Refer to SRS CONTROL UNIT (SRS-ECU) ).
STEP 3. Using scan tool MB991958, check actuator test
Check the combination meter actuator tests. Item No. 07: Indicator 1

Q: Does the SRS warning light turn on and off normally?
- YES: Go to Step 4.
- NO: Replace the combination meter. (Refer to COMBINATION METER .)
STEP 4. Wiring harness inspection between C-317 ETACS-ECU connector terminal No. 5 and C-04 combination meter connector terminal No. 2
NOTE: Prior to the wiring harness inspection, check the ETACS-ECU connector C-317, joint connector (1) C-03 and combination meter connector C-04, and repair if necessary.
- The SRS warning light inspection for open and short circuit
Q: Is the check result normal?
- YES: Replace the combination meter. (Refer to COMBINATION METER .)
- NO: Repair the wiring harness.