Knee Air Bag Module Check
WARNING:
Never attempt to measure the circuit resistance of the air bag modules (squib), even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental air bag deployment will result, and possible serious personal injury.
WARNING:
If any component damage is found during the following inspection, replace the air bag module with a new one. Dispose of the old one according to the specified procedure (Refer to AIR BAG MODULE AND SEAT BELT PRE-TENSIONER DISPOSAL PROCEDURES
).
- Check the inflator surface for cracks, dents or deformations.
- Check the air bag for breakage.
- Check the connector for damage, the terminal for deformation and the harness for binding.