TIMING CHAIN LEARNED VALUE RESET (2.0L ENGINE Non-turbo, 2.4L ENGINE)
Required Special Tools:
- MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: V.C.I.
- MB991827: M.U.T.-III USB Cable
- MB991910: M.U.T.-III Main Harness A
CAUTION:
To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
- After the ignition switch is in "LOCK" (OFF) position, connect scan tool MB991958 to the data link connector.
- Turn the ignition switch to the "ON" position.
- Select "MFI" form System select Screen of scan tool MB991958.
- Select "Special Function" form MFI Screen.
- Select "Timing chain maintenance" from Special Function Screen.
- Select "Learned value reset" form Timing chain maintenance Screen.
- Press "ON" to reset the learning value.