LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> Maintenance >> Schedule >> General Information - Lancer >> Maintenance Service (2.0L Engine Turbo) >> 14. Reserve Tank Fluid (For Active Center Differential) >> Check Fluid Level >> < When The Scan Tool Is Used >

< When The Scan Tool Is Used >

  1. Remove the trunk room side trim lid on the right of the trunk room.
    CAUTION: Turn the ignition switch to the "LOCK (OFF)" position before connecting or disconnecting the scan tool.
  2. Set the scan tool to the 16-pin data link connector. (Refer to DIAGNOSIS < ACTIVE CENTER DIFFERENTIAL (ACD) > .)
  3. Turn the ignition switch to the ON position.
  4. Using the scan tool, forcibly activate the hydraulic unit (item No. 03) to reduce the pressure inside the accumulator.
    NOTE:
    • With the forced activation (oil level check mode), the hydraulic unit direction valve is operated 20 seconds to right and left, and then the operation is cancelled automatically. Also, using the clear key on the scan tool, the activation can be forcibly cancelled.
    • When the functions are suspended by the fail-safe function, the hydraulic unit cannot be forcibly activated.
  5. Check that the oil reservoir fluid level is in between MAX and MIN.
  6. If the fluid level is not in between MAX and MIN, fill the specified fluid.

    Brand name: Mitsubishi Motors Genuine ATF SP III 

  7. Install the trunk room side trim lid.
    Fig 1: Identifying Oil Reservoir
    G09618860Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals